Cnspeed сдуть Адаптер VAG для Volkswagen/для Audi 710D FSiT TFSi(предохранительный клапан)(ДФ) /удар дампа BOV1014 TT100375

Blow Off Adaptor VAG for Volkswagen/ for Audi 710D FSiT TFSi(blow off valve)(BOV)/blow dump

BRAND NEW F***E SPACER!! for AUDI/VW 2.0T FSI AND TSI ENGINES

Sandwich type adapter that fits between the existing electrical solenoid and the turbo charger housing. On the 2.0 FSiT TFSi turbo, built into the turbocharger housing, is a

bypass facility. This allows charge air to be recirculated around the turbo charger from the boost side back to the intake side. This re-circulation path is opened and closed by means of an electrical connection from the engine management to a solenoid that is mounted on the turbocharger housing. As you accelerate , the turbo charger vanes are spinning and boost pressure is increased, literally blowing into the engine cylinders. While you change to a higher gear the throttle valve to the engine closes. The problem here is that during this process the turbo is still spinning and the boost pressure that it is producing has no where to go. (This is a bit like putting you hand over a hair dryer so the air cannot get out) What happens at this point is the turbo starts to stall, the spinning vanes slow down and the boost pressure drops. When the throttle valve opens again the turbo has lost its momentum, boost pressure and there is a pause or a "Lag" before the engine is producing the required power once again. To combat this loss of power and stress on the turbo, a re-circulation or diverter valve is used. When the throttle valve closes, the engine management opens the re-circulation route around the turbo. This gives the charge air an alternative route and allows the turbocharger to keep spinning so that when you accelerate again there is no "lag" or waiting period. This system works well and is adopted by nearly all vehicle manufacturers on turbo charged petrol engine applications. The only downside to this system is that a turbo chargers produce heat. By recirculating the hot air back into the intake side of a turbo the temperatures increase. This is where the Blow Off or Dump valve plays its part. By expelling the charge air to atmosphere rather than recirculating it, you do not increase the intake air temperature but you do allow the turbo to keep spinning. The side effect which is unacceptable to most vehicle manufacturers is the noise of the valve expelling the air. By fitting the adapter between the existing solenoid and the turbo housing (this involves removing only 3 bolts) the air is re-directed to atmosphere rather than recirculated.

Please note:

For the twin charged 1.4 engine (Turbo and Supercharger) please see FMDV14TSi

Fits: